HOT MELT GLUE GUN 10W

No. 49 | Ref: 15231 | 4u. 24u.
INSTRUCTIONS FOR USE: 1. Plug the cable into an electrical socket. 2. Insert the glue stick through the tunnel in the back of the gun. 3.Wait 5 minutes for the glue to warm up. 4. Apply the adhesive, pressing the trigger continuously. 5. Make sure the surface is clean. Press the pieces together for about 15 seconds for better adhesion. 6. Unplug the gun from the electrical outlet when work is finished.
PRECAUTIONS: 1. Do not touch the nozzle or the melted glue. It may cause burns. 2. In case of an accident, immediately place the affected area under cold water. Keep out of the reach of children. 3. If the power cable is damaged, it must be replaced to avoid any hazards.